Polymer Coatings Heavy Duty Floor Epoxy Coating

Heavy Duty Epoxy Coating is a two-component solvent based epoxy. Heavy Duty Epoxy Coating is de-signed to provide an attractive protection coating to new and existing floors and other substrates, which are easy to clean and maintain. We offer a variety of colours, which comes in a pre-measured kit form.

https://wa.me/p/6862065800578845/27837225843
Recommended uses:
This is a heavy-duty system which can be applied over your existing or new concrete, ceramic tile, wood, fiberglass, bathroom tubs ,basins and metal. It can also be installed on vertical surfaces such as steps and walls. A non-slip aggregate can be added to create a non-slip floor / walkway. Demarcation lines and traffic safety markings can also be applied.
Caution dropping sharp and or heavy objects could cause damage to the coating and the substrate and will not be seen as paint failure.
Suitable as a floor and wall coating in the following areas:
Warehouses
Aircraft Hangers & Maintenance Areas
Production Facilities
High Traffic Areas
Workshops
Vehicle Movement Areas
Cold Rooms
Walkways
Store rooms
Food processing areas
Battery, generator and pump rooms.
Laboratories
Garages
Residential Flooring
Product Properties:
Easily applied by Mohair Roller / Epoxy Pile Roller, brush, spray and airless spray.
Resistant to hot tyre marking and pick up.
High durability coating with excellent mechanical strength. (Dropping sharp and or heavy objects could damage the coating and the substrate)
Cures to a tough coating, that takes years of wear.
Water resistant
Resistant to normal household cleaning chemicals.
300 Microns thick coating (per layer applied with roller)
Available in a variety of different colours and or clear
 

Technical Data:
Colour - A variety of colours, view our RAL colour chart. Finish Gloss finish
Mix Ratio - 11 : 1 Activator - Heavy Duty Epoxy – Part B ( Hardener)
Typical Film Thickness— 350microns thick per coat (applied by roller)
Theoretical Coverage 1kg – 2 to 3 sqm at +/- 300 microns; (applied by roller)
5kg – 15 sqm at +/- 300 microns; (applied by roller)
25kg – +/- 60sqm at +/-300 microns (applied by roller)
Method of Application Brush, Mohair / Epoxy Pile Roller, spray and airless spray
Number of Coats We recommend 1 coat Epoxy Primer (helps create a pinhole free coating), and then 1 coat Heavy Duty
Epoxy, In very high traffic areas, 1 coat Epoxy Primer and 2 coats Heavy Duty Epoxy